How to Flash Samsung Samsung Galaxy Note II GT-N7100 1000% done odin tool by Smart Phone Help
Kitket 4.4.2
flash file: https://drive.google.com/uc?id=0B3qYFBKKL2hiT2FFeTBVTk1TUWs
odin 3.09: https://docs.google.com/file/d/0B4NpYCga6NXxQmR3SGxrMkd2Ync/edit
odin 3.07: https://docs.google.com/file/d/0BykP47U0ImFKWFQxakxyZllwS00/edit
like video: https://www.youtube.com/channel/UC2QH1IZ38-q-jxnpYRxutUQ?sub_confirmation=1
Thanks for watching, & please remember to Like this video, if it helped you. I will answer all comments below,
Be sure to share with your friends.
!! Please Reply Me For More Future Videos !!
Once Again, Thanks For Watching
Subscribe for more future videos
Follow these steps to enter Download Mode/Odin Mode
1:Power off your device
2:Press and hold Volume Down key, Home Key and Power Key
3:When your device vibrates, release Power key while keep holding the Volume Down key and Home key
Boot into download mode
4:Warning before entering into download mode
Press Volume Up key to enter Download mode, which has a green robot figure and “Downloading… Do not turn off target!!)
Boot into download mode
Now you are in download mode.
Step 5: Connect your device to PC.
You device should be automatically recognized by Odin. At the lower-left of Odin interface, it should show a message that says "Added!" and in the meantime you should see a light-blue box at the ID:COM section stating "COM:3" (the number depend on which USB port you have plugged the device cable and is irrelevant).
Connect device to Odin
Device is connected to Odin.
Step 6: Click "PDA" or "AP" to add tar.md5 file that you have extracted and then "Start".
Whether it is "PDA" or "AP" depends on the version of Odin that you used. But the md5 file goes to either "PDA" or "AP".
Add md5 file to Odin
Add *.md5 to Odin.
After adding the file, click "Start" to begin the flashing process.
Click start to flash stock rom
Click "Start" to flash.
WARNING DO NOT REMOVE OR OPERATE ON YOUR DEVICE UNTIL FINISHED OR FAILED IS SHOWED ON ODIN.
Starting to flash stock rom via Odin
Ongoing flashing process. Do not remove your device.
When the flashing process is done and if everything goes well, you should see a big green box saying "RESET" or "PASSED" (depends on the version of Odin is used). By now, the device should be rebooted and it is safe to remove/unplug your device.
Succeed to flash stock rom via Odin
Flash succeeded.
If failed, what should you do?
Try these things first:
Update your device driver software to the latest.
Restart your computer.
Run Odin as Administrator.
Try different cable (original one or the one with better quality) and USB port (the main port recommended)
Re-download the firmware file, make sure it is intact and match your device model
Comments
Post a Comment